Petco Automatic Cat Water Fountain

Research shows that increased water intake can improve your cat's health.

The easy to use Petco Automatic Water Fountain continually aerates your cat's water with healthful oxygen which makes the water taste fresh. In addition, the replaceable charcoal filter removes bad tastes and odors.

Our water fountain has a large 50 oz. capacity and a long 6 foot power cord making it convenient to plug in and go! Plus, it completely disassembles for cleaning.

Additional Petco Charcoal filters available, sold separately.

Keep instructions on hand for future use.

Warning: When using electrical appliances, basic precautions should always be followed, including the following: Read instructions thoroughly before using appliance. To reduce the risk of injury, close supervision is necessary when an appliance is used near children. Only use attachments recommended or sold by the manufacturer.

Do not use outdoors. FOR INDOOR USE ONLY.

Do not unplug by pulling on the power cord. To unplug, grasp the plug, not the power cord. Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions or is dropped or damaged in any manner.

For portable appliance- To reduce the risk of electrical shock, do not place or store where it can be pulled into a tub or sink. Always unplug any appliance when not in use, before putting on or taking off parts, and before cleaning. Never pull power cord to remove from outlet.

Save these instructions.

Do not run dry. For indoor use only.

As with any electrical device, check the electrical cord for any tears or damage before use.

Directions for use: Rinse the filter thoroughly under cool water before placing into the motor/filter housing area. Rinsing will remove a majority of the loose charcoal dust which is harmless to pets. Remove the top bowl by placing your index fingers underneath each side of the top bowl and lift up from lower bowl. Set top bowl off to side. After rinsing, insert charcoal filter. The filter will fit into slots on each side of the motor housing area. The white side of the filter should be facing out toward the front of the lower fountain bowl. Put the bowl back in place. Place the fountain in desired location. The use of a protective mat is suggested to protect your floor from splashes or drips which may occur during use by your pet. Before you plug in the fountain, make sure the cord and your hands are dry. Plug in the fountain. Fill the unit with water. This includes both the lower and top bowls of the fountain. After the fountain pump becomes primed and begins regular operation, add the fountain tube insert for the drinking fountain effect.

Add water as needed. Water should always be maintained between the minimum and maximum water lines indicated on the inside of the lower bowl.

The fountain must be cleaned regularly. Cleaning frequency depends on the number of pets using the fountain and quality of your water.

Filters should be replaced approximately every 2-4 weeks. For replacement filters, visit a Petco store near you or purchase online at www.petco.com.